- Once you are done subsampling into lysis solution, the plate must be entered into LIMS.
- Bring the box of tissue as well as the plate with lysis solution in it to the computer with a scanner.
- Find LIMS (it is bookmarked on the internet) and go to Stage Selection.
- Select Lysis With Plate Transfer (or Lysis in Plate, if lysis solution was added directly to the plate of tissue and nothing was subsampled).
- Put a barcode on the lysis plate (these can be found near the computer in the lab, if you cannot find any, see Printing Barcodes for Plates).
- Take out your LIMS card and scan your barcode in User Barcode.
- The Start Plate is box of tissue. The End Plate is barcode you just put on the plate with lysis solution.
- Beside Select Protocol select the type of lysis solution used.
- Press Submit.
- Nothing should happen. The barcode that was in the start plate and end plate boxes should now be blank, but it will not give you a reassuring message about the information going through.
Updated April 27 2009